AQUAA SOLUTION Fully Automatic Water Level Controller & Indicator with 3 Carbon 1.5m Wire Wired Sensor Security System

Three sensors provided to be installed in water tanks. Sensors placement should be as shown in this image. All three sensors into water tank is required for fully automatic operation. "OL" required to start the motor when water reach below the sensor. "OH" required to stop the motor when water reaches the sensor. ""High quality long durability sensors"'' Three numbers of sensors provided with this controller. This sensors are having best in quality sensing material and having 1.5 meter wire attached with it. Sensors having all the wires in three colour . Just need to be installed as per diagram on the controller. "Cable selection for controller" 1.0 square mm wire and below this size cables are accepted to be used for sensor installations. Small gauge wires can obtain more distance covered between sensor to controller. Higher gauge in wire can loss the signal between controller and sensor. Recommended wires for sensor installations are, Telephone cable, 0.5 square mm three core wire, internet cable or 0.25 square mm three core flexible wires. For power connections 2.5 square mm wires should be used. "This controller can not be connected with button type multi-capacitor starters" We advice please do not buy this controller if pump starter have red and green operative buttons and multi capacitors inside the starters. Only mcb type starters and having running capacitor starters can be used with this controller