DAZZRIDE 3D Fake Car Engine Cover Universal Scoops Cover Bonnet Car Decorative Air Flow Boonet Scoop

Before installation, Match the body and the surface of the car to confirm the installation position. At this time, decorate the inside of the wind net itself (the double-sided tape) as a whole, and find the grounding place (see whether it is curved). Caution If the product is installed in the curved place of the car body, if the product is damaged, there will be insufficient adhesion strength, and the product may fall off. Note When installing the door or the vicinity of the door, be sure to open and close the door in advance to ensure that there is no contact. After the installation position is determined, mark it when the protective film and the car body are matched. Note Please paste once carefully when pasting. If you re-open it and paste it again, the adhesive force will be weakened, so please be sure to paste it once. When the temperature is very low, use a hair dryer to heat the sticking surface before sticking Press the entire adhesive surface of the Duct, and press again to ensure that the paste is complete. Note Within 24 hours after installation, the adhesive strength of the double-sided tape will be weakened, so please avoid applying vibration or contact with water